lock_runtime is a stack variable whose contents could be completely
garbage, but only the 'locked' member was zeroed. zero the whole
thing to prevent spurious "recursive spinlock" errors from occasionally
popping up as the validation framework gets confused from garbage
data in the other memebers of this data structure.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
It should be nrfx_power_clock_irq_handler, not nrfx_clock_irq_handler.
The latter is only present as a function if both nrfx CLOCK and POWER
drivers are used and it is then called from the actual IRQ handler,
which is always named nrfx_power_clock_irq_handler (also when only
the nrfx CLOCK driver is used as in case of this test).
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
Add a build only test to validate correct compilation of the uart_rtt
driver. No harness that connects to RTT is defined, and therefore the
test can't be run by CI.
Signed-off-by: Jordan Yates <jordan.yates@data61.csiro.au>
Add Kconfig with the following options:
- DMA_LOOP_TRANSFER_DRV_NAME to set the DMA device name, because
some SOCs do not allow memory to memory DMA on all DMA devices
- DMA_LOOP_TRANSFER_CHANNEL_NR some SOCs start counting the DMA
channels at 1 instead of 0.
Signed-off-by: Erwin Rol <erwin@erwinrol.com>
FS_TYPE_END is no longer used as there is no hard-coded limit on the
number of file systems. Replace with the limit used when only in-tree
file systems are enabled.
The test for unsupported file systems is no longer valid. Instead
verify that attempting to register a file system when there is no room
for it fails as expected.
Signed-off-by: Peter A. Bigot <pab@pabigot.com>
Use platform_allow instead of platform_exclude, as the test depends
on specific boards. A new board with DAC support should not be added
to this test automatically.
Signed-off-by: Martin Jäger <martin@libre.solar>
Memory mapping, for now, will be a private kernel API
and is not intended to be application-facing at this time.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
We no longer plan to support a split address space with
the kernel in high memory and per-process address spaces.
Because of this, we can simplify some things. System RAM
is now always identity mapped at boot.
We no longer require any virtual-to-physical translation
for page tables, and can remove the dual-mapping logic
from the page table generation script since we won't need
to transition the instruction point off of physical
addresses.
CONFIG_KERNEL_VM_BASE and CONFIG_KERNEL_VM_LIMIT
have been removed. The kernel's address space always
starts at CONFIG_SRAM_BASE_ADDRESS, of a fixed size
specified by CONFIG_KERNEL_VM_SIZE.
Driver MMIOs and other uses of k_mem_map() are still
virtually mapped, and the later introduction of demand
paging will result in only a subset of system RAM being
a fixed identity mapping instead of all of it.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
Flash memory can be write but there is no way to check flash integrity.
Add flash_img_check method that verify flash integrity. This is useful
to avoid firmware reboot and test. Another use is ensure that firmware
upgrade routines from internet server to flash slot are performing
properly. This uses flash_area_check_int_sha256 method to check a
SHA-256 hash. On sucess match, zero is returned, otherwise a negative
errno value.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
Add SHA-256 flash integrity method. It reads flash data from a
device giving an offset creating a SHA-256 hash to be compared
with a reference. On sucess match, zero is returned, otherwise
a negative errno value.
Signed-off-by: Gerson Fernando Budke <nandojve@gmail.com>
If the recvfrom() in the test returns EAGAIN, try again in order
to make sure that we have really received the data.
Fixes#27963
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
In order to be possible to debug usermode threads need to be able
issue breakpoint and debug exceptions. To do this it is necessary to
set DPL bits to, at least, the same CPL level.
Signed-off-by: Flavio Ceolin <flavio.ceolin@intel.com>
Remove special handling of the ARM Cortex-M1 DesignStart FPGA reference
design running on the Digilent Arty after CONFIG_NUM_IRQS was reduced
from 8 to 7.
Signed-off-by: Henrik Brix Andersen <henrik@brixandersen.dk>
Extend check to determine a usable ARM NVIC IRQ line to verify that the
IRQ line is not always pending.
Signed-off-by: Henrik Brix Andersen <henrik@brixandersen.dk>
We add a simple test-case for verifying the behavior of the
Cortex-M IRQ target state management. We add an additional
test only for TrustZone-enabled Cortex-M targets running
in Secure mode. We explicitly exclude ARMv8-M platforms that
enable Non-Secure FW build by default from running the test.
Signed-off-by: Ioannis Glaropoulos <Ioannis.Glaropoulos@nordicsemi.no>
Now that device_api attribute is unmodified at runtime, as well as all
the other attributes, it is possible to switch all device driver
instance to be constant.
A coccinelle rule is used for this:
@r_const_dev_1
disable optional_qualifier
@
@@
-struct device *
+const struct device *
@r_const_dev_2
disable optional_qualifier
@
@@
-struct device * const
+const struct device *
Fixes#27399
Signed-off-by: Tomasz Bursztyka <tomasz.bursztyka@linux.intel.com>
At present this test uses an EEPROM emulator. Reuse the same test to
also use the real Atmel AT2x driver and an AT24 emulator, via the I2C
emulation controller.
EEPROM reads and writes for eeprom1 go through the AT2x driver, which
converts them to I2C transactions, which are passed through to the
AT24 emulator for processing. This approach makes more use of 'real'
code, in this case the Atmel AT2x driver.
Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>
Signed-off-by: Simon Glass <sjg@chromium.org>
In NPCX7M6FB, it uses some the IRQs at the end of the vector table,
for example, the irq 60 and 61 used for Multi-Input Wake-Up Unit (MIWU)
device by default, and conflicts with isr used for testing. Moving IRQs
for this test suite to solve the issue.
Signed-off-by: Mulin Chao <MLChao@nuvoton.com>
Add gpio support for Nuvoton NPCX series. This CL includes:
1. Add GPIO device tree declarations.
2. Introduce wui_maps property in yaml file to present relationship
between Wake-Up
Input (WUI) and 8 IOs belong to the device.
3. Zephyr GPIO api implementation.
4. GPIO callback functions implementation with MIWU api functions.
5. Overlay file for gpio basic tests
Signed-off-by: Mulin Chao <MLChao@nuvoton.com>
Unit tests may include C++ code, so ensure the compiler flags are
consistent to avoid link errors.
Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>
The value of adv_type shall be 0x07 for extended advertising, it will
be converted to 0x05 inside ll_adv_params_set after some checks.
This did not cause any issues with tests since input parameters in
already implemented test cases do not test any code that was skipped
by invalid parameter, however obvious one side-effect is that phy_p
would be always set to 1M regardless of input parameter so any test
case using Coded on primary would fail.
Signed-off-by: Andrzej Kaczmarek <andrzej.kaczmarek@codecoup.pl>
Added tests to update AD data as fast as possible. This test
shall exercise any race condition assert checks in the
Zephyr BLE controller implementation.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Increased sim_length value to 60 seconds so as to meet the
current length of 13.56 seconds and any future test timing
increases in the near future.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Update bsim test to test Periodic Advertising Enable and
Disable alongwith Extended Advertising Enable/Disable.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
After the fallthrough comments have been replaced (see commit
741ad17a37) with a macro expanding
to the corresponding attribute, those hints became statements,
and if one happens to occur before any switch case, a warning
reporting it as an unreachable statement is generated.
Prevent the above from happening for function ll_rx_dequeue() in
ull.c by enabling an option that will make some switch case to
appear before this problematic statement.
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
Update the driver implementation to use nrfx_clock and nrfx_power
drivers. Update also revisions of the hal_nordic and nrf_hw_models
modules, so that it is actually possible to use those drivers.
Signed-off-by: Krzysztof Chruscinski <krzysztof.chruscinski@nordicsemi.no>
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
To debug hard-to-reproduce faults/panics, it's helpful to get the full
register state at the time a fault occurred. This enables recovering
full backtraces and the state of local variables at the time of a
crash.
This PR introduces a new Kconfig option, CONFIG_EXTRA_EXCEPTION_INFO,
to facilitate this use case. The option enables the capturing of the
callee-saved register state (r4-r11 & exc_return) during a fault. The
info is forwarded to `k_sys_fatal_error_handler` in the z_arch_esf_t
parameter. From there, the data can be saved for post-mortem analysis.
To test the functionality a new unit test was added to
tests/arch/arm_interrupt which verifies the register contents passed
in the argument match the state leading up to a crash.
Signed-off-by: Chris Coleman <chris@memfault.com>
Trims the default memory configuration for the BBC Microbit in mesh
samples to ensure that it fits.
Signed-off-by: Trond Einar Snekvik <Trond.Einar.Snekvik@nordicsemi.no>
This patch introduces some tests for the LED drivers. The following
functions of the LED API are tested:
- led_get_info
- led_on
- led_off
- led_set_color
- led_set_brightness
Note that the led-controller-0 alias must be defined in the DTS of the
board used to run this tests.
Signed-off-by: Simon Guinot <simon.guinot@seagate.com>
Some ARMv8-M platforms may come with only 8 (instead of 16)
MPU regions. In these platforms, by design, a memory domain
may contain up to 2 application memory partitions, when we
build with MPU_GAP_FILLING support. To be able to test this
valid configuration we slightly modify the test code in the
mem_protect suite, and add-remove the second partition (with
index-1) instead of the third (index-2).
Signed-off-by: Ioannis Glaropoulos <Ioannis.Glaropoulos@nordicsemi.no>
We need to exclude the .gap_filling test from running on
ARMv8-M platforms with 8 MPU regions available, since the
userspace test defines and uses a memory domain whose number
of partitions exceed the maximum number of permitted partitions
in ARMv8-m SoCs with MPU_GAP_FILLING=y.
Signed-off-by: Ioannis Glaropoulos <Ioannis.Glaropoulos@nordicsemi.no>
Adding the first list item in the same line as @details, creates a list
with a single item inside a paragraph, and another list with the
remaining items. What is wanted here is to have a single list with all
items, so the first item needs to be in a new line.
Signed-off-by: Fabio Utzig <fabio.utzig@nordicsemi.no>
The spi_flash_w25qxxdv driver has been superseded by the generic
spi_nor driver for over a year. The only non-refactoring change to
the W25Q driver in the last 18 months was done to support a backport
to 1.14.
All devices supported by spi_flash_w25qxxdv driver are expected to be
supported by the spi_nor driver, using the standard `jedec,spi-nor`
devicetree compatible. No in-tree devicetree files make use of this
driver.
Remove the confusion about which driver to select by removing the
unmaintained redundant driver.
Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>
Add more tests to verify that we discard malformed packets.
In order to simplify the testing, separate message validation to
dns_validate_msg() function in resolve.c. Allow that function to
be called from unit test. This way we can construct invalid DNS
messages in unit test and verify that they are discarded when
needed.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Tests need to be adjusted to do the correct checks now that reference
count is incremented in z_reserve_fd() instead of z_finalize_fd().
test_z_fd_multiple_access in particular has been simplified to
reserving an fd in one thread and freeing it in the other.
Signed-off-by: Vincent Wan <vwan@ti.com>
Add some tests for testing AF_PACKET and SOCK_DGRAM type
sockets. These are sockets where Ethernet header is automatically
added, caller just needs to provide upper stack header.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
We don't have use-cases and it introduces complexities with
allocating page tables on MMU systems.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
Align all Kconfig option names with LVGL names. The followed rule:
LV_(.*) -> CONFIG_LVGL_(.*).
Also replaced LVGL boolean configuration entries using if/else/endif
with direct IS_ENABLED macro.
Signed-off-by: Gerard Marull-Paretas <gerard@teslabs.com>
