The check for label property is really checking to see if a device
exists and the better way to do that is to use DT_HAS_NODE(). Replace
refernces of DT_NODE_HAS_PROP(DT_INST(...), label) with
DT_HAS_NODE(DT_INST(...)).
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Converts the usdhc driver to the new gpio api. Updates the
device tree for the mimxrt1050_evk board to set appropriate active
high/low polarity for the power and card detect pins.
Note that the driver doesn't actually support interrupts yet. It
initializes a gpio callback for the card detect pin, but never actually
enables the gpio interrupt. This incomplete behavior is left as-is,
since the purpose of this patch is only to convert the driver to the new
gpio api, not to add new features.
Signed-off-by: Maureen Helm <maureen.helm@nxp.com>
Remove leading/trailing blank lines in .c, .h, .py, .rst, .yml, and
.yaml files.
Will avoid failures with the new CI test in
https://github.com/zephyrproject-rtos/ci-tools/pull/112, though it only
checks changed files.
Move the 'target-notes' target in boards/xtensa/odroid_go/doc/index.rst
to get rid of the trailing blank line there. It was probably misplaced.
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
The usdhc driver was incorrectly post-decrementing a do/while loop
iterator, causing an extra iteration of the loop and an out-of-bounds
array access. Change the iterator to decrement within the loop instead.
Tested samples/subsys/fs/fat_fs on the mimxrt1050_evk board.
Coverity-CID: 203403
Signed-off-by: Maureen Helm <maureen.helm@nxp.com>
