Nordic devices detect edge interrupts through the PORT event which is
generated on a rising edge of DETECT, which itself is asserted when any
GPIO is configured for sense level detection and the GPIO's input signal
matches the configuration.
The previous code in Zephyr attempts to detect when at least one GPIO
SENSE signal is still asserted, and intentionally leaves the PORT event
uncleared to ensure the interrupt is re-entered.
This approach fails when no pin satisfies its SENSE condition during the
check but at least one input changes level between the completion of the
check and the clear of the PORT event. Such a failure can be observed
on the pca20020 hardware when multiple sensors configured for level
triggers are active. In this situation the corresponding sensor trigger
signals remain asserted but the PORT event required to drive their
processing has already been cleared.
The fix is to ensure that the SENSE configuration for all GPIOs across
all port instances is disabled prior to unconditionally clearing the
PORT event, then re-enabling the SENSE configuration for all GPIOs once
callbacks associated with detected SENSE triggers have been performed.
The act of re-enabling will ensure any relevant SENSE condition causes a
new rising edge on DETECT and so a new PORT event.
Closes issue #11806
See: https://devzone.nordicsemi.com/f/nordic-q-a/7246/missing-interrupts-on-gpioe-port-events
Signed-off-by: Peter A. Bigot <pab@pabigot.com>
These changes modify the function of reading port/pin,
function return logical sum of input pin value and
output pin values for a given port. It is now possible
to read the status of pins set as output.
Signed-off-by: Kamil Gawor <Kamil.Gawor@nordicsemi.no>
These changes were obtained by running a script created by
Ulf Magnusson <Ulf.Magnusson@nordicsemi.no> for the following
specification:
1. Read the contents of all dts_fixup.h files in Zephyr
2. Check the left-hand side of the #define macros (i.e. the X in
#define X Y)
3. Check if that name is also the name of a Kconfig option
3.a If it is, then do nothing
3.b If it is not, then replace CONFIG_ with DT_ or add DT_ if it
has neither of these two prefixes
4. Replace the use of the changed #define in the code itself
(.c, .h, .ld)
Additionally, some tweaks had to be added to this script to catch some
of the macros used in the code in a parameterized form, e.g.:
- CONFIG_GPIO_STM32_GPIO##__SUFFIX##_BASE_ADDRESS
- CONFIG_UART_##idx##_TX_PIN
- I2C_SBCON_##_num##_BASE_ADDR
and to prevent adding DT_ prefix to the following symbols:
- FLASH_START
- FLASH_SIZE
- SRAM_START
- SRAM_SIZE
- _ROM_ADDR
- _ROM_SIZE
- _RAM_ADDR
- _RAM_SIZE
which are surprisingly also defined in some dts_fixup.h files.
Finally, some manual corrections had to be done as well:
- name##_IRQ -> DT_##name##_IRQ in uart_stm32.c
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
Replaces direct accesses to the peripheral registers structure
with the proper GPIOTE HAL function added recently to nrfx.
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
Commit fixes two issues:
- Return correct value from gpiote_channel_alloc
- Check if pending event interrupt was not disabled
Jira:DESK-270
Fixes#9535
Signed-off-by: Pawel Dunaj <pawel.dunaj@nordicsemi.no>
