Enables Networking hardware on i.MX-RT 1050-EVKB board.
Pinout enabled board specific etherenet connection, also pin
initialization was moved later to PRE_KERNEL_2 in order to have
sysclock initialized before.
Signed-off-by: Andrei Gansari <andrei.gansari@nxp.com>
Add driver for i.MX Messaging Unit peripheral which can be used for
i.MX6SoloX, i.MX7D and other i.MX socs.
Origin: Original
Signed-off-by: Stanislav Poboril <stanislav.poboril@nxp.com>
These changes were obtained by running a script created by
Ulf Magnusson <Ulf.Magnusson@nordicsemi.no> for the following
specification:
1. Read the contents of all dts_fixup.h files in Zephyr
2. Check the left-hand side of the #define macros (i.e. the X in
#define X Y)
3. Check if that name is also the name of a Kconfig option
3.a If it is, then do nothing
3.b If it is not, then replace CONFIG_ with DT_ or add DT_ if it
has neither of these two prefixes
4. Replace the use of the changed #define in the code itself
(.c, .h, .ld)
Additionally, some tweaks had to be added to this script to catch some
of the macros used in the code in a parameterized form, e.g.:
- CONFIG_GPIO_STM32_GPIO##__SUFFIX##_BASE_ADDRESS
- CONFIG_UART_##idx##_TX_PIN
- I2C_SBCON_##_num##_BASE_ADDR
and to prevent adding DT_ prefix to the following symbols:
- FLASH_START
- FLASH_SIZE
- SRAM_START
- SRAM_SIZE
- _ROM_ADDR
- _ROM_SIZE
- _RAM_ADDR
- _RAM_SIZE
which are surprisingly also defined in some dts_fixup.h files.
Finally, some manual corrections had to be done as well:
- name##_IRQ -> DT_##name##_IRQ in uart_stm32.c
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
CONFIG_ADC_QMSI and CONFIG_ADC_QMSI_SS aren't defined anywhere so
remove the dead CMake references to them.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Peripheral drivers are already available but cannot be enabled trough
Kconfig. This allow project to use nrfx drivers.
Signed-off-by: Christopher Métrailler <christopher.metrailler@nordicsemi.no>
This makes it possible for the application to enable building of the
GPIOTE and PPI subsystems in NRFX.
Signed-off-by: Jonas Norling <jonas.norling@greeneggs.se>
The build script ext/hal/nordic/CMakeLists.txt manages the MDK
dependency. The MDK is not aware of Zephyr and uses it's own defines
to indicate what HW we are building for.
This commit moves these MDK-specific defines out of the 'soc' build
scripts and into the MDK build script where they belong.
This is expected to be a pure refactoring without side-effects.
Signed-off-by: Sebastian Bøe <sebastian.boe@nordicsemi.no>
This patch introduce version which add two new features:
- ability to resume partial upload
- option to not compile taskstat and echo commands
Origin: mcumgr
License: Apache 2.0
URL: https://github.com/apache/mynewt-mcumgr
Commit: 6251689367fcfe92898b90978b877a242b6e4b24
Purpose: New features
Maintained-by: External
Signed-off-by: Szymon Janc <szymon.janc@codecoup.pl>
As RTT is used by more subsystem in Zephyr, initialization is moved
from RTT console and RTT logger backend to common kernel init phase.
Signed-off-by: Pavel Kral <pavel.kral@omsquare.com>
This option allows to explicitly include Segger RTT libraries and
enables use of it for various subsystems. It is disabled by
default as it consumes more RAM.
Signed-off-by: Pavel Kral <pavel.kral@omsquare.com>
Add logger backend that uses Segger RTT for message output. Several
options are provided allowing configuration of up-buffer and logger
behaviour.
Signed-off-by: Pavel Kral <pavel.kral@omsquare.com>
The Silicon Labs EFR32MG12P Mighty Gecko MCU includes:
* Cortex-M4F core at 40MHz
* up to 1024KB of flash and 256KB of RAM
* integrated Sub-GHz and/or 2.4GHz radio
* multiple low power peripherals
Signed-off-by: Diego Sueiro <diego.sueiro@gmail.com>
Signed-off-by: Endre Karlson <endre.karslon@gmail.com>
Origin: Silicon Labs EFR32MG12P Mighty Gecko Series Device Support
CMSIS PACK
URL: https://www.silabs.com/documents/public/cmsis-packs/SiliconLabs.EFR32MG12P_DFP.5.5.0.pack
Version: 5.5.0 (2018-05-07)
Purpose: Add support for Silicon Labs EFR32MG12P SoCs
License: Zlib
Maintained-by: External
To update the Gecko SDK, download the current version from the given URL
rename .pack to .zip, unpack and replace the following folder:
* Device/SiliconLabs/ should replace
ext/hal/silabs/gecko/Device/SiliconLabs
Signed-off-by: Diego Sueiro <diego.sueiro@gmail.com>
Add a missing "V" in _EMU_EM23PERNORETAINCTRL_DAC0DIS_MASK ->
_EMU_EM23PERNORETAINCTRL_VDAC0DIS_MASK in em_emu.h
Signed-off-by: Diego Sueiro <diego.sueiro@gmail.com>
LL_EXTI_LINE_18 and LL_EXTI_LINE_20 are declared in stm32f7xx_hal_pcd.h
and in stm32f7xx_ll_exti.h which generates warnings. Set #ifndef
in stm32f7xx_ll_exti.h around declarations.
STBugtracker: 55274
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
LL_EXTI_LINE_18 and LL_EXTI_LINE_20 are declared in stm32l4xx_hal_pcd.h
and in stm32l4xx_ll_exti.h which generates warnings. Set #ifndef
in stm32l4xx_ll_exti.h around declarations.
STBugtracker: 55275
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
The toolchain information is using out of date (and misspelled)
environment variables. Rather than duplicate information here which is
already present in the getting started guide, just link to it.
Clean up some other docs.
Signed-off-by: Marti Bolivar <marti@foundries.io>
The system tick count is a 64 bit quantity that gets updated from
interrupt context, meaning that it's dangerously non-atomic and has to
be locked. The core kernel clock code did this right.
But the value was also exposed to the rest of the universe as a global
variable, and virtually nothing else was doing this correctly. Even
in the timer ISRs themselves, the interrupts may be themselves
preempted (most of our architectures support nested interrupts) by
code that wants to set timeouts and inspect system uptime.
Define a z_tick_{get,set}() API, eliminate the old variable, and make
sure everyone uses the right mechanism.
Signed-off-by: Andy Ross <andrew.j.ross@intel.com>
Contrary to what was written in its Kconfig, hal/altera depends not
on Newlib, but on a baseline POSIXish define like O_NONBLOCK. Minimal
libc now provides them, so there're no issues with building Altera
for either minimal on newlib libc.
Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>
Header include "arm_math.h" causes duplicate symbol error on build.
Signed-off-by: Marcio Montenegro <mtuxpe@gmail.com>
Signed-off-by: Christian Taedcke <hacking@taedcke.com>
This patch integrates EFM32HG support into the build
infrastructure of Zephyr.
Signed-off-by: Marcio Montenegro <mtuxpe@gmail.com>
Signed-off-by: Christian Taedcke <hacking@taedcke.com>
This includes:
* the Gecko SDK files for the EFM32HG SoCs
Origin: Silicon Labs Gecko SDK
URL: https://github.com/SiliconLabs/Gecko_SDK
Version: v5.1.2 (SHA: 938464c68e6c3b2237388a692f767bb0767ec010)
Purpose: Add support for Silicon Labs EFM32 Happy Gecko SoCs
License: Zlib
Maintained-by: External
To update the Gecko SDK, download the current version from the given URL
and replace the following folders:
* Gecko_SDK/platform/Device/ should replace ext/hal/silabs/gecko/Device/
Signed-off-by: Marcio Montenegro <mtuxpe@gmail.com>
A new CAN API is now provided in stm32cube packages.
STM32 can driver is implemented on top of initial CAN API which
is now legacy API.
Disable new API and enable legacy.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Format all cube packages to the same format before update to new
versions:
-Apply dos2unix
-Remove trailing white spaces
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Format all cube packages to the same format before update to new
versions:
-Apply dos2unix
-Remove trailing white spaces
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Format all cube packages to the same format before update to new
versions:
-Apply dos2unix
-Remove trailing white spaces
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Format all cube packages to the same format before update to new
versions:
-Apply dos2unix
-Remove trailing white spaces
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Format all cube packages to the same format before update to new
versions:
-Apply dos2unix
-Remove trailing white spaces
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
This patch introduce version which fixes following bug:
It was possible to erase slot 1 while it stores confirmed image
while ongoing test run - this is unwanted behavior which allow
to even brick remote device accidentally.
This patch add check for such case of test run etc.
This also aligns condition required for erase command
execution to similar as upload command requires.
Origin: mcumgr
License: Apache 2.0
URL: https://github.com/apache/mynewt-mcumgr
Commit: 91a76b95b1b81aba06e30ee168e5ee5975cdfe93
Purpose: Bug Fix
Maintained-by: External
Signed-off-by: Andrzej Puzdrowski <andrzej.puzdrowski@nordicsemi.no>
