Following migration of all in-tree boards to device tree bindings
for USB pins configuration, deprecate USB related macros.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Following migration of all in-tree boards to device tree bindings
for ADC pins configuration, deprecate ADC related macros.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Following migration of all in-tree boards to device tree bindings
for SPI pins configuration, deprecate SPI related macros.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Following migration of all in-tree boards to device tree bindings
for I2C pins configuration, deprecate I2C related macros.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Following migration of all in-tree boards to device tree bindings
for CAN pins configuration, deprecate DAC related macros.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Following migration of all in-tree boards to device tree bindings
for serial pins configuration, deprecate (LP)U(S)ART related macros.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
The STM32L072CZ MCU has a built-in USB device controller which is
supported by Zephyr's USB STM32 driver. The b_l072z_lrwan1 board has a
micro-USB connector that is wired to the MCU via two solder bridges
(SB15 and SB16) that need to be closed to connect the data lines.
Update the board documentation to describe the solder bridges and
enable the USB controller in the device tree.
Signed-off-by: Andreas Sandberg <andreas@sandberg.pp.se>
To work efficiently, SPI_NSS pins require pull-up configuration.
Fix this for whole STM32 series.
Fixes#17998
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Fixes#16739. Changed the STM32's SPI MISO/MOSI configurations in order
to reduce the power consumption by approximately 20uA per pin.
According to STM32's Application Notes on GPIO configuration for
low-power consumption, the input pins should be configured with internal
pull-up or pull-down resistor. If a pin is configured as a floating
input, and there is no signal present, the Schmitt trigger randomly
toggles between the logical levels induced by the external noise, thus
increasing the consumption.
Signed-off-by: Ioannis Konstantelias <ikonstadel@gmail.com>
This commit adds pinmux defines for all the external ADC lines
supported by stm32. All defines are named after the datasheet of the
corresponding product lines.
Signed-off-by: Song Qiang <songqiang1304521@gmail.com>
Fix issue #9028: last bit of SPI/I2S transaction may be corrupted.
Impacted STM32 SOC series: F0/F1/F2/F3/F4/L0.
Notes:
- F2/F4/L0: set gpio to very_high speed ('11')
- F0/F3: set gpio to high speed ('11').
- F1: set gpio to 50MHz.
Signed-off-by: Armando Visconti <armando.visconti@st.com>
Any word started with underscore followed by and uppercase letter or a
second underscore is a reserved word according with C99.
Signed-off-by: Flavio Ceolin <flavio.ceolin@intel.com>
