Move to CMake 3.20.0.
At the Toolchain WG it was decided to move to CMake 3.20.0.
The main reason for increasing CMake version is better toolchain
support.
Better toolchain support is added in the following CMake versions:
- armclang, CMake 3.15
- Intel oneAPI, CMake 3.20
- IAR, CMake 3.15 and 3.20
Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>
The PR fixes the pwm_led sample:
- now test doesn't rely on any specific device name
- Logs which are scanned with regex in the test are printed
only after a command passes (before failures were not
affecting the test verdict)
- If 1 sec cycle is not supported appropriate info is printed
and won't cause the test to failed
- Changed second "Turned off" msg so regex doesn't mix it with the
the first one.
Fixes#35524
Signed-off-by: Maciej Perkowski <Maciej.Perkowski@nordicsemi.no>
If the label property is missing in a "pwm-leds" compatible DT node
(which is almost always the case), then the device name is now set to
DT_NODE_FULL_NAME instead of "LED_PWM_$inst" previously.
This allows applications to use the DEVICE_DT_NAME macro to retrieve
the device name instead of gessing an arbitrary string.
Signed-off-by: Simon Guinot <simon.guinot@seagate.com>
Modify led_pwm sample in order to make it usable in device testing:
- Remove parenthesis from the logs as they prevent use of regex
- Add a harness_config multiline regex in order to enable verdict
generation
- Update README
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
The sanity check on this sample gives timeout failure
on reel board because of bad filtering. Because the
sample does not adopt ztest framework, sanitycheck in
our daily test will report this as failure, which lowers
our passrate but this is not a sample with errors.
Signed-off-by: Shihao Shen <shihao.shen@intel.com>
This sample allows to test the led-pwm driver. The first "pwm-leds"
compatible device instance found in DT is used. For each LEDs attached
to this device (child nodes) the same test pattern (described below) is
executed. The LED API functions are used to control the LEDs.
Test pattern:
For each PWM LEDs (one after the other):
- turn on
- turn off
- increase the brightness gradually up to the maximum level
- blink (0.1 sec on, 0.1 sec off)
- blink (1 sec on, 1 sec off)
- turn off
Signed-off-by: Simon Guinot <simon.guinot@seagate.com>
