Paul Sokolovsky 416d397233 drivers: eth_mcux: By default use 1 buffer each for hardware RX/TX ... It was reported, and confirmed by multiple parties that default CONFIG_ETH_MCUX_RX_BUFFERS=2 under some packet load leads to 1s and increasing packet processing delay and eventual deadlock. No reports were about CONFIG_ETH_MCUX_TX_BUFFERS=2, but be on safe side and just set that to the minimal value as the current default, to allow us to have good conservative base to test various networking stack issues. Fixes: #3132 Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>		2019-01-21 12:40:33 +02:00
..
CMakeLists.txt	drivers: eth_smsc911x: Add driver for SMSC9118 aka LAN9118 chip	2019-01-19 11:59:29 -05:00
eth_dw_priv.h
eth_dw.c
eth_e1000_priv.h
eth_e1000.c
eth_enc28j60_priv.h
eth_enc28j60.c	drivers: eth_enc28j60: moved to dts	2019-01-16 21:28:23 -05:00
eth_mcux.c
eth_native_posix_adapt.c
eth_native_posix_priv.h
eth_native_posix.c
eth_sam_gmac_priv.h
eth_sam_gmac.c
eth_smsc911x_priv.h	drivers: eth_smsc911x: Add driver for SMSC9118 aka LAN9118 chip	2019-01-19 11:59:29 -05:00
eth_smsc911x.c	drivers: eth_smsc911x: Add driver for SMSC9118 aka LAN9118 chip	2019-01-19 11:59:29 -05:00
eth_stellaris_priv.h
eth_stellaris.c
eth_stm32_hal_priv.h
eth_stm32_hal.c
Kconfig	drivers: eth_smsc911x: Add driver for SMSC9118 aka LAN9118 chip	2019-01-19 11:59:29 -05:00
Kconfig.dw
Kconfig.e1000
Kconfig.enc28j60	drivers: eth_enc28j60: moved to dts	2019-01-16 21:28:23 -05:00
Kconfig.mcux	drivers: eth_mcux: By default use 1 buffer each for hardware RX/TX	2019-01-21 12:40:33 +02:00
Kconfig.native_posix
Kconfig.sam_gmac
Kconfig.smsc911x	drivers: eth_smsc911x: Add driver for SMSC9118 aka LAN9118 chip	2019-01-19 11:59:29 -05:00
Kconfig.stellaris
Kconfig.stm32_hal
phy_sam_gmac.c
phy_sam_gmac.h