mirror of
https://github.com/zephyrproject-rtos/zephyr
synced 2025-08-31 23:26:22 +00:00
a38bb31df5
Update nucleo_f446re to fit with default configuration guidelines: - add spi support - configure I2C1 as arduino i2c and spi1 as arduino spi - update yaml - disable I2C by default - update doc Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
46 lines
1.1 KiB
Plaintext
46 lines
1.1 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_BOARD_NUCLEO_F446RE=y
|
|
CONFIG_SOC_SERIES_STM32F4X=y
|
|
CONFIG_SOC_STM32F446XE=y
|
|
# 96MHz system clock (highest value to get a precise USB clock)
|
|
CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=96000000
|
|
CONFIG_SYS_CLOCK_TICKS_PER_SEC=1000
|
|
|
|
# Enable MPU
|
|
CONFIG_ARM_MPU=y
|
|
|
|
CONFIG_SERIAL=y
|
|
|
|
# console
|
|
CONFIG_CONSOLE=y
|
|
CONFIG_UART_CONSOLE=y
|
|
|
|
# enable pinmux
|
|
CONFIG_PINMUX=y
|
|
|
|
# enable GPIO
|
|
CONFIG_GPIO=y
|
|
|
|
# clock configuration
|
|
CONFIG_CLOCK_CONTROL=y
|
|
|
|
# Clock configuration for Cube Clock control driver
|
|
CONFIG_CLOCK_STM32_HSE_CLOCK=8000000
|
|
CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y
|
|
# use HSE as PLL input
|
|
CONFIG_CLOCK_STM32_PLL_SRC_HSE=y
|
|
# however, the board does not have an external oscillator, so just use
|
|
# the 8MHz clock signal coming from integrated STLink
|
|
CONFIG_CLOCK_STM32_HSE_BYPASS=y
|
|
|
|
# produce 84MHz clock at PLL output
|
|
CONFIG_CLOCK_STM32_PLL_M_DIVISOR=8
|
|
CONFIG_CLOCK_STM32_PLL_N_MULTIPLIER=384
|
|
CONFIG_CLOCK_STM32_PLL_P_DIVISOR=4
|
|
CONFIG_CLOCK_STM32_PLL_Q_DIVISOR=8
|
|
CONFIG_CLOCK_STM32_AHB_PRESCALER=1
|
|
|
|
# APB1 clock must not exceed 50MHz limit
|
|
CONFIG_CLOCK_STM32_APB1_PRESCALER=2
|
|
CONFIG_CLOCK_STM32_APB2_PRESCALER=1
|