mirror of
https://github.com/zephyrproject-rtos/zephyr
synced 2025-08-15 08:35:23 +00:00
448acf527f
SPI, to control the CC2520 chip, is the only generic feature and thus the only one configurable through Kconfig. GPIO on the other end depends a lot on the SoC/Board. Adding a slave select option as well. Change-Id: I63068fab476ed8d5b26103e4ad20e5be253c9932 Signed-off-by: Tomasz Bursztyka <tomasz.bursztyka@linux.intel.com>
59 lines
2.0 KiB
C
59 lines
2.0 KiB
C
/*
|
|
* Copyright (c) 2015 Intel Corporation
|
|
*
|
|
* Licensed under the Apache License, Version 2.0 (the "License");
|
|
* you may not use this file except in compliance with the License.
|
|
* You may obtain a copy of the License at
|
|
*
|
|
* http://www.apache.org/licenses/LICENSE-2.0
|
|
*
|
|
* Unless required by applicable law or agreed to in writing, software
|
|
* distributed under the License is distributed on an "AS IS" BASIS,
|
|
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
|
|
* See the License for the specific language governing permissions and
|
|
* limitations under the License.
|
|
*/
|
|
|
|
#include <nanokernel.h>
|
|
#include "board.h"
|
|
#include <uart.h>
|
|
#include <device.h>
|
|
#include <init.h>
|
|
|
|
#if defined(CONFIG_NETWORKING_WITH_15_4_TI_CC2520)
|
|
|
|
#include <802.15.4/cc2520_arch.h>
|
|
|
|
struct cc2520_gpio_config **cc2520_gpio_configure(void)
|
|
{
|
|
struct device *gpio;
|
|
|
|
int flags_int = GPIO_INT | GPIO_INT_LEVEL |
|
|
GPIO_INT_ACTIVE_HIGH | GPIO_INT_DEBOUNCE;
|
|
int flags_int_in = flags_int | GPIO_DIR_IN;
|
|
int flags_noint_out = GPIO_DIR_OUT;
|
|
int flags_noint_in = GPIO_DIR_IN;
|
|
|
|
gpio = device_get_binding(CONFIG_GPIO_DW_0_NAME);
|
|
gpio_pin_configure(gpio, CONFIG_CC2520_GPIO_FIFOP, flags_int_in);
|
|
gpio_pin_configure(gpio, CONFIG_CC2520_GPIO_FIFO, flags_noint_in);
|
|
gpio_pin_configure(gpio, CONFIG_CC2520_GPIO_CCA, flags_noint_in);
|
|
gpio_pin_configure(gpio, CONFIG_CC2520_GPIO_SFD, flags_noint_in);
|
|
|
|
cc2520_gpio_config[CC2520_GPIO_IDX_FIFOP].gpio = gpio;
|
|
cc2520_gpio_config[CC2520_GPIO_IDX_FIFO].gpio = gpio;
|
|
cc2520_gpio_config[CC2520_GPIO_IDX_SFD].gpio = gpio;
|
|
cc2520_gpio_config[CC2520_GPIO_IDX_CCA].gpio = gpio;
|
|
|
|
gpio = device_get_binding(CONFIG_GPIO_DW_1_NAME);
|
|
gpio_pin_configure(gpio, CONFIG_CC2520_GPIO_VREG, flags_noint_out);
|
|
gpio_pin_configure(gpio, CONFIG_CC2520_GPIO_RESET, flags_noint_out);
|
|
|
|
cc2520_gpio_config[CC2520_GPIO_IDX_VREG].gpio = gpio;
|
|
cc2520_gpio_config[CC2520_GPIO_IDX_RESET].gpio = gpio;
|
|
|
|
return (struct cc2520_gpio_config **)&cc2520_gpio_config;
|
|
}
|
|
|
|
#endif /* CONFIG_NETWORKING_WITH_15_4_TI_CC2520 */
|