mirror of
https://github.com/zephyrproject-rtos/zephyr
synced 2025-09-07 10:02:34 +00:00
db167c606d
We use the following commands to rename any
LED._GPIO_{CONTROLLER,PIN,FLAGS} to
DT_ALIAS_LED._GPIOS_{CONTROLLER,PIN,FLAGS}
git grep -l LED._GPIO_CONTROLLER | xargs sed -i 's/LED\(.\)_GPIO_CONTROLLER/DT_ALIAS_LED\1_GPIOS_CONTROLLER/g'
git grep -l LED._GPIO_PIN | xargs sed -i 's/LED\(.\)_GPIO_PIN/DT_ALIAS_LED\1_GPIOS_PIN/g'
git grep -l LED._GPIO_FLAGS | xargs sed -i 's/LED\(.\)_GPIO_FLAGS/DT_ALIAS_LED\1_GPIOS_FLAGS/g'
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
|
||
|---|---|---|
| .. | ||
| src | ||
| CMakeLists.txt | ||
| prj.conf | ||
| README.rst | ||
| sample.yaml | ||
.. _blink-led-sample: PWM: Blink LED ############## Overview ******** This is a sample app which blinks a LED using PWM. The LED will start at a blinking frequency of 1 Hz. Every 4 seconds, the blinking frequency will double. When the blinking frequency reaches 64 Hz, the blinking frequency will be halved every 4 seconds until the blinking frequency reaches 1 Hz. This completes a whole blinking cycle. This faster-then-slower LED blinking cycle repeats forever. Wiring ****** Nucleo_F401RE, Nucleo_L476RG, STM32F4_DISCOVERY, Nucleo_F302R8 ============================================================== Connect PWM2(PA0) to LED Nucleo_F103RB ============= Connect PWM1(PA8) to LED Nucleo_L496ZG ============= No special board setup is necessary because there are three on-board LEDs (red, green, blue) connected to the Nucleo's PWM. Hexiwear K64 ============ No special board setup is necessary because there is an on-board RGB LED connected to the K64 PWM. nrf52840_pca10056 ================= No special board setup is necessary because there is an on-board LED connected. Arduino 101 =========== You will need to connect the LED to ground and PWM0 via the shield. You may need a current limiting resistor. See your LED datasheet. Building and Running ******************** This sample can be built for multiple boards, in this example we will build it for the nrf52840_pca10056 board: .. zephyr-app-commands:: :zephyr-app: samples/basic/blink_led :board: nrf52840_pca10056 :goals: build flash :compact: After flashing the image to the board, the user LED on the board should start to blinking as discussed in overview