mirror of
https://github.com/zephyrproject-rtos/zephyr
synced 2025-08-11 15:55:53 +00:00
7eabab2f5d
When using an IDE (e.g. Eclipse, Qt Creator), the project name gets displayed. This greatly simplifies the navigation between projects when having many of them open at the same time. Naming every project "NONE" defeats this functionality. This patch tries to use sensible project names while not duplicating too much of what is already represented in the path. This is done by using the name of the directory the relevant CMakeLists.txt file is stored in. To ensure unique project names in the samples (and again, in the tests folder) folder, small manual adjustments have been done. Signed-off-by: Reto Schneider <code@reto-schneider.ch> |
||
|---|---|---|
| .. | ||
| src | ||
| CMakeLists.txt | ||
| prj_nrf52832_mdk.conf | ||
| prj_nrf52840_mdk.conf | ||
| prj_nrf52840_pca10056.conf | ||
| prj.conf | ||
| README.rst | ||
| sample.yaml | ||
.. _blink-led-sample: PWM: Blink LED ############## Overview ******** This is a sample app which blinks a LED using PWM. The LED will start at a blinking frequency of 1 Hz. Every 4 seconds, the blinking frequency will double. When the blinking frequency reaches 64 Hz, the blinking frequency will be halved every 4 seconds until the blinking frequency reaches 1 Hz. This completes a whole blinking cycle. This faster-then-slower LED blinking cycle repeats forever. Wiring ****** Arduino 101 and Quark D2000 CRB =============================== You will need to connect the LED to ground and PWM0 via the shield. You may need a current limiting resistor. See your LED datasheet. Nucleo_F401RE, Nucleo_L476RG, STM32F4_DISCOVERY, Nucleo_F302R8 ============================================================== Connect PWM2(PA0) to LED Nucleo_F103RB ============= Connect PWM1(PA8) to LED Hexiwear K64 ============ No special board setup is necessary because there is an on-board RGB LED connected to the K64 PWM. nRF52840_PCA10056 ================= No special board setup is necessary because there is an on-board LED connected. Building and Running ******************** This sample can be built for multiple boards, in this example we will build it for the arduino_101 board: .. zephyr-app-commands:: :zephyr-app: samples/basic/blink_led :board: arduino_101 :goals: build flash :compact: After flashing the image to the board, the user LED on the board should start to blinking as discussed in overview