Daniel Leung 8f6068e9d8 serial/ns16550: make IRQ triggering condition a SoC decision ... The IRQ triggering condition should be specified by SoC as it is a decision for hardware design. This should not be configurable in kconfig. The default is to be triggered on rising edge, just as the same old kconfig did. Change-Id: If59d88a30711eb8e03d9cc4f409055cefe1995c5 Signed-off-by: Daniel Leung <daniel.leung@intel.com>		2016-03-30 13:38:34 +00:00
..
Kconfig	serial/ns16550: make IRQ triggering condition a SoC decision	2016-03-30 13:38:34 +00:00
Kconfig.atmel_sam3	serial: minor kconfig semantic changes	2016-03-17 21:05:11 +00:00
Kconfig.k20	serial/k20: remove base addr, irq and clk freq from kconfig	2016-03-26 20:36:32 -04:00
Kconfig.ns16550	serial/ns16550: reduce number of kconfig options	2016-03-30 13:38:34 +00:00
Kconfig.nsim
Kconfig.qmsi
Kconfig.stellaris	serial/stellaris: remove base addr, irq and clk freq from kconfig	2016-03-26 20:36:32 -04:00
Kconfig.stm32	serial/stm32: add support for IRQ APIs	2016-03-18 20:52:00 +00:00
Makefile	serial/stm32: add driver for STM32 UART	2016-03-18 20:20:28 +01:00
uart_atmel_sam3.c
uart_k20_priv.h
uart_k20.c	serial/k20: remove base addr, irq and clk freq from kconfig	2016-03-26 20:36:32 -04:00
uart_k20.h
uart_ns16550.c	serial/ns16550: reduce number of kconfig options	2016-03-30 13:38:34 +00:00
uart_ns16550.h
uart_nsim.c	drivers: Replace DEV_INVALID_OP by -ENOTSUP	2016-03-16 19:30:04 -04:00
uart_qmsi.c	uart: Enable QMSI driver for Quark D2000	2016-03-18 23:33:06 +00:00
uart_stellaris.c	serial/stellaris: remove base addr, irq and clk freq from kconfig	2016-03-26 20:36:32 -04:00
uart_stellaris.h
uart_stm32.c	serial/stm32: add support for IRQ APIs	2016-03-18 20:52:00 +00:00
uart_stm32.h	serial/stm32: add support for IRQ APIs	2016-03-18 20:52:00 +00:00